Innovate-motorsports LC-2 Manual de usuario

11-0137 LC-2 Digital Air/Fuel Ratio (Lambda) Sensor Controller Manual Warning! The Oxygen Sensor used in this device gets very hot in operati

10 unit of measure displayed. When programming by AFR the LM Programmer converts the number to Lambda before programming the LC-2. So there might be

11 5.3.3 Updating the Firmware Do not update the firmware if the versions are the same. A firmware update should only be necessary if there has been

12 6 LC-2 Error Codes and Troubleshooting Tips Error Code Error Message Likely Root Cause Fix Error 1 Heater circuit shorted Short in sensor Repl

2 1 LC-2 The LC-2 is a controller that controls a wideband O2 lambda sensor to measure O2 content in exhaust gasses. In this section we will spend a

3 2. After the initialization, the status light will light will blink or light up constant up to indicate one of the following operational status co

4 2 The circuit to which you will pull power from should be able to support an additional 3 amp draw. Make sure the connection is fused with a minim

5 2.2.1 Single Innovate Device Relay Wiring Instructions 3 Sensor Placement Optimum bung placement will vary from application to application, but

6  A 1” bung (provided in the kit) will best protect the sensor. When fully threaded, the sensor’s tip will sit flush with the exhaust pipe, this do

7 The calibration procedure requires that the oxygen sensor be in free air, this means removed from the exhaust system completely. 1. With the sen

8 - Calibrate once per race weekend Dyno use - Calibrate new sensor - Calibrate every 2-3 days, depending on usage 5 Software (LogWorks 3 and LM Pro

9 Innovate Motorsports (P/N 3733) or use any USB to serial adaptor that includes drivers. Make sure that nothing is connected to the IN port of the L