Innovate-motorsports MTX-L Manual de usuario

11-0129A MTX-L Digital Air/Fuel Ratio Gauge User Manual Warning! The Oxygen Sensor used in this device gets very hot in operation.

10 This shows the analog output voltages versus Lambda for one of the two analog outputs. The graph display is automatically scaled to the selected

11 of 14 and .1 V for an AFR of 15. Other settings, of course, are easily programmable between the minimum and maximum range specified earlier. Avoi

12 3. On the very first tab of LM Programmer you will see a button labeled “Update Firmware,” click this button. 4. Select the firmware file with t

13 3.5 Customizing your display range The MTX-L gauge can be setup to display different ranges from both the Needle Bar and the Numeric

14 4 Wiring Analog Outputs The analog outputs on the MTX-L are ‘single ended’. That is, each output uses just one wire. It is assumed that the MTX-

15 Appendix A: Limited Warranty LIMITED WARRANTY Innovate stands behind the quality of its products. Innovate makes the following warranty to purcha

16 Appendix B: MTX-L Error Codes and Troubleshooting Tips Error Code Error Message Likely Root Cause Fix Error 1 Heater circuit shorted Short in se

2 TABLE OF CONTENTS 1 MTX-L...3 2 Installatio

3 1 MTX-L The MTX-L is an integrated gauge and controller for wideband AFR (lambda) measurements. Although it can be operated stand alone, it has di

4 2 Installation 2.1 Wiring The MTX-L has 5 stripped wire ends: 1 Connect the RED wire to an isolated switched 12V source in your vehicle. A swi

5 2.1.1 Single Innovate Device Relay Wiring Instructions 2.2 Mounting and Routing The MTX-L gauge fits in any standard 2 1/16” (52mm) gauge pod.

6 2.3 Sensor Placement Optimum bung placement will vary from application to application, but using the guideline below will ensure the longest sens

7  The maximum temperature of the sensor at the bung (the sensor mounting location) should not exceed 500 oC or 900 oF. If these temperatures are e

8 2.4.1 Calibration Schedule Normally aspirated (daily driver) - Calibrate before installation of new sensor - Calibrate new sensor again after 3 m

9 3.1 Installing software 1. Double click on the Logworks 3 installer previously downloaded. 2. The installer will start, follow the prompts to i